Use a broadcast interval of at least 1 to 2 minutes. All others use a path of WIDE1-1,WIDE3-2 for 3 hops, WIDE1-1,WIDE2-1 for 2 hops, WIDE1-1 for 1 hop.On Kenwood radios use New-N, WIDE1-1 ON, total hops maximum 3.If you want to keep traffic limited to Luxembourg use LX in place of WIDE.Do not broadcast every 1 or 2 minutes! Static information shall not interfere in the APRS network.Use a broadcast interval of at least 20 to 30 minutes.All others use a path of WIDE3-3 for 3 hops, WIDE2-2 for 2 hops, WIDE2-1 for 1 hop.On Kenwood radios use New-N, WIDE1-1 OFF, total hops maximum 3.Just follow the suggestions of the makers of APRS and you are on the right side. Use the following setup for Luxembourg: All digipeaters of the LARU follow this scheme.ĮNDUSERS: It is important to configure your radio correctly in order to avoid overloading the APRS network. WIDEn-N is the standard path, LXn-N is the regional path limiting traffic to Luxembourg (replacing LUXn-N), TEMP is an emergency path. SYSOPS: APRS digipeaters in Luxembourg should support the following paths suggested by the makers of APRS:
0 Comments
Leave a Reply. |